HOW TO CHANGE THE SIT MEANS SIT REMOTE BATTERY
If you need to replace the rubber charge port cover on your remote transmitter, this should be done while changing the battery as they both require opening the remote transmitter. Visit HOW TO REPLACE THE RUBBER COVER ON YOUR SIT MEANS SIT REMOTE TRANSMITTER for more information.
Remove the screws from the back of the remote with a #1 Phillips screwdriver. Then remove the back cover.
Pinch the wires firmly between 2 fingers. With the other hand press one finger against the back of the remote transmitter.
Carefully pull the battery’s wire plug out of the connector in the remote transmitter.
If it doesn’t initially come out, pull harder.
Recycle the battery as recommended by your local waste facility.
Take the new battery’s wire plug and insert it into the connecter in the remote transmitter. Then place the battery inside the back of the remote transmitter.
Remove the rubber gasket from the battery cover. You can do this with a paperclip or something similar.
Wipe out any dirt or debris that has built up.
Replace the gasket with the new gasket provided in your battery replacement kit.
This step is important for the remote remain waterproof.
Put the front and back of the remote back together, and hand-tighten all 8 screws.
Be careful not to fasten the screws too tight as this can damage the remote.
You will need to pair your remote transmitter and collar after replacing the battery. Please refer to HOW TO PAIR YOUR SIT MEANS SIT REMOTE TRANSMITTER AND COLLAR. or if you have more than one collar to pair- HOW TO ADD ANOTHER DOG’S COLLAR RECEIVER TO YOUR SIT MEANS SIT TRAINER.
CONTACT CUSTOMER CARE
If you need further assistance, please contact our customer care team.